STORAGE

1.To store the inLine® Inversion System, simply keep it in a clean dry place.

2.Move the inLine® Inversion System by lifting the frame and moving slowly. NOTE: Two people are required to move the inLine® Inversion System.

MAINTENANCE

The safety and integrity designed into the inLine® Inversion System can only be maintained when the inLine® Inversion System is regularly examined for damage and wear. Special attention should be given to the following:

1.Check the pivot arms, cushions, foam pads, and foam pads adjustment device for damage and wear.

2.Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten loose nuts and bolts.

3.Verify that the WARNING LABEL(50) is in place and easy to read. Call Stamina Products immediately at 1-800-375-7520for a replacement WARNING LABEL(50) if it is missing or damaged.

4.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

5.Worn or damaged components shall be replaced immediately or the inLine® Inversion System removed from service until repair is made.

6.Only Stamina Products supplied components shall be used to maintain/repair the inLine® Inversion

System.

7.Keep your inLine® Inversion System clean by wiping it off with an absorbent cloth after use.

12

Page 12
Image 12
Stamina Products 55-1510 owner manual Storage, Maintenance