ASSEMBLY INSTRUCTIONS
STEP 4
Place a SPACER(61) on each side of the SHAFT on the UPRIGHT(2). Slide the PIVOTING ARMS(71) onto the SHAFT on the UPRIGHT(2) on both sides and secure with SECURING CAPS(49), WASHERS (ø10xø19x2mm thick)(46), and NYLOCK NUTS(M10x1.5)(47).
STEP 5
Slide the lower end of the PIVOTING ARM(71) into the bracket on the PEDAL ARM(9), and secure with the SHOULDER BOLT(ø15.9x77mm, M10x1.5 threaded)(13), WASHER(M10xø21x1.5mm thick)(60), and NYLOCK NUT(M10x1.5)(47). Refer to the Section View. Make sure the shoulder of the SHOULDER BOLT(ø15.9x77mm, M10x1.5 threaded)(13) is fully gone through the holes of the bracket on the PEDAL ARM(9) before tightening the NYLOCK NUT(M10x1.5)(47). Repeat to attach the opposite side.
Shoulder
Bracket
SECTION VIEW
9
