Stamina Products Inmotions Attach the Bumper STANDS22 to the bottom of the Base FRAME1

ASSEMBLY INSTRUCTIONS

STEP 3: Place the BASE FRAME(1) between the LEFT and RIGHT UPRIGHTS(2, 3) and secure with HEX BOLTS(M12 x 70mm)(39) and WASHERS(M12)(48). DO NOT TIGHTEN COMPLETELY.

STEP 4: Secure the U-SHAPED HANDRAIL(5) onto the LEFT and RIGHT UPRIGHTS(2, 3) with BUTTON HEAD BOLTS(6mm x 15mm)(40) and ARC WASHERS(M6)(44). Connect the UPPER EXTENSION WIRE(28) to the LOWER EXTENSION WIRE(29).

STEP 5: Go back and tighten HEX BOLTS(M12 x 70mm)(39) in STEP 2. Connect the LOWER EXTENSION WIRE(29) located on the LEFT UPRIGHT(2) to the SENSOR WIRE(30). Insert the PULL PIN(9) through the RIGHT UPRIGHT(3) and BASE FRAME(1) to lock the BASE FRAME(1) in

position.

STEP 6: Install two "AA" batteries into the METER(26), two batteries included. See page 8 for detailed battery installation instructions. Slide the METER(26) onto the plate on the U-SHAPED HANDRAIL(5). Connect the UPPER EXTENSION WIRE(28) to the METER(26).

STEP 7: Attach the BUMPER STANDS(22) to the bottom of the BASE FRAME(1).

NOTE: The BUMPER STANDS(22) may be stored on the end of the BASE FRAME(1) to increase the angle of the treadmill and reduce the walking resistance. See page 10 for details on adjusting the walking resistance.

7