Standard Horizon CP500 Making Additional Routes, Creating a Route Using Marks on the Chart

Figure 9.1 - Route Report

4.When finished press [ENT] to save.

5.Press [CLR] to show the Chart page.

9.2MAKING ADDITIONAL ROUTES

To create another Route the GPS Chart Plotter must be told that you want to create a second Route.

1. Press [ROUTE] and then [REPORT].

2. Move the ShuttlePoint knob to highlight SELECT and press [ENT].

3. Move the ShuttlePoint knob to an open Route number: example, Route 2. Press [ENT].

4. Press [CLR].

5. To create the new Route, follow now the steps in the previous section “Creating a Route using Waypoints”.

WAAS 3D

Figure 9.2 - Create additional Route

9.3CREATING A ROUTE USING MARKS ON THE CHART PAGE

To create a Route containing Marks you first must create the Marks and show them on the Chart page.

1. Move the ShuttlePoint knob over the top of a Mark that you wish to be the starting point in the Route and press [ROUTE].

2. Next move the ShuttlePoint knob until the cursor is over the Mark that you want to be the next leg in the Route.

3. Press [ROUTE]. You will notice a bearing line joins the first and second Mark which means these Marks are selected into the Route.

4. Repeat steps 3 and 4 until all Marks are entered into the Route.

NOTE

At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific name follow the steps on the previous 9.1 paragraph.

Page 52 CP500