TE C H N I CA L S P E C I FI CA TI O N S
Line inputs: 8(RCA), 150 mV / 27K ohm
Phono inputs: 4(RCA), 3mV / 47K ohm
DJ mic input: 3(XLR, 1/4“), 2.45 mV / 3K ohm
Master output: 1(RCA), 1.2 V / 1K ohm
Record output: 1(RCA), 245 mV / 10K ohm
Headphone output: 1(1/4”), 32 -200 ohms recommended
Frequency Response: 20 Hz - 20 kHz, +/- 2dB
Tone Control : +9/-26 dB (Hi, Mid, L ow)
Mic Tone: Hi/Mid/Lo+/-10 dB
Gain Control: 0-20dB
S/N Ratio: Less than 70dB
T.H.D: less than 0.2%
Dimension(LxWxD): 19” x 8.75” x4” (482 x 222 x102 mm)
WA R R A N TY
This unit has been designed and manufactured using quality
components. Therefore, it is warranted to be free from defects in materi-
als (limited as specified below), and workmanship for a period of twelve
(12) months from the original purchase date. During this period, all
service and parts necessary to repair a defect will be free of charge. This
limited warranty applies to mechanical parts which are subject to wear
and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from
defects in materials and workmanship for a period of thirty days (30)
days from the original purchase date.
FOR THE WA R R A N TY TO BE VA LID, PLEASE CO M PLE TE THE
O N LINE WA R R A N TY REGIS T R ATION FOR M FOUND AT
W W W. STA N TO N M AG N E TI CS . CO M
Stanton Magnetics, LLC,
Hollywood, FL 33020
27. Fader Start connector: Connects to the sound module’s remote start output (such as
Stanton’s S-Series CD players) to control the cue-start via the mixer’s crossfader.
28. Audio signal outputs: Master output connects to an amplifier, EQ, crossover, or other
outboard signal processing. Record out connects to tape recorder, mini disk recorder,
etc. Booth output is a second master output used mostly for in-booth monitoring.
29. AC cord connector: Input connection for the supplied removable AC cord.