Stanton T.12OC manual Specifications, Part Names & Functions, Application, Turntable Section

PART NAMES & FUNCTIONS

19)COUNTERWEIGHT

Use this to balance the tone arm and to adjust the stylus pressure. See “tone arm and cartridge settings” for proper adjustments.

20)45-RPM ADAPTOR HOLDER

Place on the attached 45-rpm adaptor here. Push down the rear side of 45 rpm adaptor to take it.

21)EXTRA STYLUS HOLDER Place extra headshells here.

22 23 24 25

22)PHONO/LINE OUTPUT L & R

This is the standard analog output (RCA jacks) which can be connected either to a phono or line input on any DJ mixer, depending on the setting of the phono / line selector.

23)PHONO/LINE SWITCH

24)POWER CORD CONNECTOR

Used to connect the included power cord.

25)POWER SWITCH

This switch turns the power on or off, including the motor and audio signal.

SPECIFICATIONS

APPLICATION:

This specification applies to the direct drive turntable unit T.120C

STANDARD TEST CONDITION:
Ambient Temperature	20 +/- 2 degC
Relative Humidity	65% +/- 5%

NOTE: Measurements can be carried out between 5 degC to 35 degC and 45% to 85% relative humidity.

TURNTABLE SECTION:
Type	3-speed full manual
Motor	16pole, 3phase,brushless DC motor
Speeds	331/3 and 45rpm and 78rpm
Wow and Flutter	Less than 0.1% WRMS (JIS WTD) with 331/3rpm
Pitch Controls	+/- 8%, +/-25%, +/-50%
Starting Torque	More than 4.5kgf.cm
Starting Time	0.2~6 sec.(Adjustable)
Braking Time	0.2~6 sec.(Adjustable)
Braking System	Electronic brake
Pitch Bend	+/-6%