17
Chapter 2: Control Panel Operations
The control panel gives you push-button control over the printer’s power and
paper feed operations. It also includes indicator lights, which tell you the current
status of the printer at a glance.
This chapter describes general functions that can be performed using the control
panel buttons while the printer is turned on and either on-line or off-line. The
buttons perform different functions in the EDS and Dot Adjustment Modes.
Functions of control panel buttons in these modes are described in the relevant
sections covering them.
Important!
The procedures described in this chapter will not work if paper is not loaded
into the printer. Be sure to use the procedures on pag e 9 of this manual to load
paper before trying any of the following operations.

Switching between on-line and off-line

❏Press ON LINE to switch the printer between being on-line and off-line.
❏When the printer is on-line, the ON LINE indicator is lit and the printer can
receive data from the computer. You should make sure that the printer is on-
line whenever you are trying to print.
❏When the printer is in off-line, the ON LINE indicator goes out, which
means that the printer cannot receive any data.
Important!
Make sure that the on-line/off-line setting of the printer is correct before
performing any other control panel operations.
FONT MODE LF ON LINE
ROMAN
COURIER
SANSERIF
PRESTIGE
ORATOR
POWER
DRAFT
QUIET
BANK SW
A1
B2
C3
D4
E5
6
F
MICRO FEED
FF
QUIET