– 103 –
APPENDIX
Connecting the peripheral drive cable
Connect the peripheral drive cable to the connector on the printer. Then, connect
the other end of the cable to the peripheral drive circuit.
For EU
Except for EU
1Install the ferrite core onto the peripheral drive cable as shown in the
illustration.
EU only
Ferrite core
(EU only)
Ethernet cable
EU only
10cm
(Maximum)
Fastener
EU only
2Pass the fastener through the holes in the ferrite core as shown in the
illustration.
3Loop the fastener around the cable, and then pull the end of the fastener tightly
through its buckle. Use a pair of scissors to cut off the excess end of the
fastener.