Instruction Manual
Installation
Note: Although FAN939775HP supports a variety of different CPUs, the illustrations below depict installation on an Intel chipset. Installation steps are identical for both AMD and Intel chipsets, with the exception of the parts used. When installing FAN939775 on a Socket AM2 system, please ensure that the motherboard already has the AM2 retention module (mounting bracket), and use the K8 clip.
1.Remove the original CPU cooler and any devices used to retain the CPU within the socket.
2.Place the base clip
backing onto the backside of the motherboard
3.Apply enough thermal paste to the top of the CPU to cover the entire top surface.
4.Remove the protective film from the base on the heat pipe main unit. Place the main unit on the CPU, aligning the holes of the P4 clip with the posts.
5.Place the retention clip inside the frame of the heatpipe base, then install the main unit onto the CPU, being sure to line the clip up with the posts.
6.Tighten the posts to secure the heatpipe unit onto the mainboard.
7.Put the transparent frame onto the main unit, directing the fan as required by the structure of your computer contents.
8.Using the screw kit, screw the frame into the main unit.
9.Connect the power cord from the fan speed controller to the main unit/frame.
10.Connect the remaining power cable to the motherboard.
11.Secure the fan speed controller into an open slot on the back of the computer.
12.Check to make sure the main unit is securely positioned on the mainboard.
3
