FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electric switch;
do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas suppliers instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1. | STOP! Read safety information above on this label. | 9. | Push in control knob all the way and hold down. | |||||||
2. | Set the thermostat to lowest setting by turning the |
| Immediately light the pilot with a match. Continue to hold | |||||||
| water temperature dial clockwise ( | ) to its lowest |
| control knob in for about one (1) minute after the pilot is | ||||||
| temperature setting (with arrow on dial) as shown. |
| lit. Release knob and it will pop back up. Pilot should | |||||||
| DO NOT FORCE. |
|
|
|
|
| remain lit. If it goes out, repeat steps 3 through 8. | |||
3. | Remove outer door. |
|
|
|
| • If knob does not pop up when released, stop | ||||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
| and immediately call your service technician | |||
|
|
|
|
|
|
| or gas supplier. |
| ||
|
|
|
|
|
|
| • If the pilot will not stay lit after several tries, | |||
|
|
|
|
|
|
|
| depress and turn the gas control knob | ||
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| clockwise | to “OFF” and call your | ||
4. | Turn gas control knob clockwise | to “OFF” |
| service technician or gas supplier. | ||||||
| position. Knob cannot be turned from “PILOT” to “OFF” | 10. | Replace (or close) inner door. Replace outer | |||||||
| unless knob is depressed slightly. DO NOT FORCE. | |||||||||
|
| door if door does not cover gas control on/off | ||||||||
5. | Wait five (5) minutes to clear out any gas. If you |
| ||||||||
| knob or temperature adjustment knob. | |||||||||
| then smell gas, STOP! Follow “B” in the safety |
| ||||||||
| 11. | At arms length away, turn gas control knob | ||||||||
| information above on this label. If you don't smell gas, | |||||||||
| go to next step. |
|
|
|
|
| counter- clockwise | to the full “ON” | ||
6. | Remove (or open) inner door located below gas |
| position. WARNING: Do not use gas control | |||||||
| control unit. |
|
|
|
|
| knob to regulate gas flow. | |||
7. | Find pilot - follow metal tube from gas control. The pilot |
| ||||||||
12. | At arms length away, set the thermostat to | |||||||||
| is located in front of the burner or on the right hand | |||||||||
|
| desired setting. The | mark ( ) indicative of | |||||||
| side of the burner. |
|
|
|
| |||||
| PILOT |
| approximate 120°F is preferred starting point. | |||||||
| PILOT |
|
| |||||||
|
| BURNER |
| Some local laws may require a lower starting | ||||||
| BURNER |
|
| |||||||
| OR |
|
|
| ||||||
|
| *THERMOCOUPLE |
| point. If hotter water is desired, see instruction | ||||||
|
|
|
|
| ||||||
|
|
|
|
| manual and “warning” below. | |||||
8. | If you don’t smell gas, turn knob on gas control counter |
| ||||||||
| clockwise |
| to “PILOT” position. | 13. | Replace the outer door if not replaced in step 10. |
WARNING
Hotter water increases the risk of scald injury. Before changing temperature setting see instruction manual.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting by turning the water | 2. | Turn gas control knob clockwise | to “OFF” | |
temperature dial clockwise ( | ) to its lowest |
| position. Knob cannot be turned from “PILOT” to “OFF” | |
temperature setting (with arrow on dial) as shown. DO |
| unless knob is depressed slightly. DO NOT FORCE. | ||
NOT FORCE. |
|
| ||
| 3. | Replace outer door (if removed). |
| |
|
|
|
10