State Industries SSE-120, SSE-5 Foreword, Table Of Contents, Approvals Model & Rating Plate, Asme

FOREWORD

Detailed installation diagrams are in this manual. These diagrams will serve to provide the installer with a reference for the materials and method of piping suggested. IT IS NECESSARY THAT ALL WATER PIPING AND THE ELECTRICAL WIRING BE INSTALLED AND CONNECTED AS SHOWN IN THE DIAGRAMS.

Particular attention should be given to the installation of thermometers at the locations indicated in the diagrams as these are necessary for checking the operation of the heater.

In addition to these instructions, the equipment shall be installed in accordance with those installation regulations in force in the local area where installation is to be made. Authorities having jurisdiction shall be consulted before installations are made.

BE SURE TO TURN OFF POWER WHEN WORKING ON OR

NEAR THE ELECTRICAL SYSTEM OF THE HEATER. NEVER TOUCH ELECTRICAL COMPONENTS WITH WET HANDS OR WHEN STANDING IN WATER. WHEN REPLACING FUSES ALWAYS USE THE CORRECT SIZE FOR THE CIRCUIT. SEE PAGE 14.

DO NOT TEST ELECTRICAL SYSTEM BEFORE HEATER IS FILLED WITH WATER, FOLLOW START UP PROCEDURE ON PAGE 17.

The principal components of the heater are identified on page 4. The model and rating plate on page 3 interprets certain markings into useful information. Both of these references should be used to identify the heater, its components and optional equipment.

TABLE OF CONTENTS
	PAGE
ROUGH-IN-DIMENSIONS	2
RECOVERY CAPACITY	2
FOREWORD	3
TABLE OF CONTENTS	3
APPROVALS & MODEL & RATING PLATE	3
GETTING TO KNOW YOUR WATER HEATER	4
GENERAL SAFETY INFORMATION
Insulation Blankets	5
External Damage	5
INSTALLATION
Required Ability	5
General	5
Location	5
Connections	5
Relief Devices	6
Temperature Limiting Control	6
Hydrogen Gas (Flammable)	6
PIPING DIAGRAMS	7-12
ELECTRICAL
General	13
Branch Circuit	13

	PAGE
Amperage Table/Overcurrent Protection	14
Heater Circuits	14
Control Circuit	14
Power Circuit	14
Wiring Diagram	15-17
OPERATION
General	18
Filling	18
Start Up	18
Temperature Regulation	18-19
Draining	19
MAINTENANCE
General	19
Flushing	19
Sediment Removal	19
Lime Scale Removal	19-20
Checklist	20-21
Anode Maintenance	21
Replacement Parts	21
LEAKAGE CHECKPOINTS	22
LIMITED WARRANTY	23

APPROVALS MODEL & RATING PLATE

	All models bear the
	National Sanitation
	Foundation seal of
	approval.
	All models are
	listed by
	Underwriters’
	Laboratories, Inc.
ASME	125 PSI Working Pressure
	(65 thru 120 Gallons)
	150 PSI Working Pressure
	(5 thru 50 Gallons)

3