Sterling SVL-A, SVL-B, SVL-C, SVL-D - page 15

SVL-A, SVL-B, SVL-C, & SVL-D Self-Contained Material Loaders - Venturi Style 15 of 49

2-3 Installing the Control Assembly

Install the control assembly at a freely accessible site. Check the length of the

connection cable and the length of the supplied hoses to the venturi assemblies.

During installation of equipment, check the length of the air supply lines. In some

cases, longer air supply lines may be required.

Figure 2.9: Control Assembly and Mounting Bracket

Shop Air To Venturi

Assembly

Control Mounting

Bracket

Contents

Main Operation and Installation Instructions Effective: 7/2007 Self-Contained Material Loader (Compressed Air Venturi Type) SVL-A, SVL-B, SVL-C, & SVL-D Page Shipping Information Unpacking and Inspection In the Event of Shipping Damage If the Shipment is Not Complete If the Shipment is Not Correct Table of Contents Chapter 1: Safety Instructions...................................................6 Chapter 2: Installation.............................................................. 10 CHAPTER 3: FUNCTIONAL DESCRIPTION............................ 10 CHAPTER 4: SETUP................................................................. 10 CHAPTER 6: TECHNICAL DATA............................................. 10 Chapter 1: Safety Instructions 1-1 How to Use This Manual Safety Symbols Used in this Manual DANGER! 1-3 For Your Safety 1-4 Unit Safety Chapter 2: Installation Note: SVL-A, SVL-B, SVL-C, & SVL-D Self-Contained Material Loaders - Venturi Style 11 of 49 OR OR OR 2-2 Installing the Material Receiver Depending on the position, drill the holes for fastening the Make sure all equipment is properly grounded to minimize Page Note: Page 2-4 Connecting the Compressed Air Supply Note: 2-5 Connecting Material Lines Note: Note: 2-6 Electrical Connection Chapter 3: Functional Description 3-1 Operational Summary 3-2 Method of Functioning 3-3 Control Assembly Chapter 4: Setup 4-1 Preparations 4-2 Adjusting Compressed Air Flow Note: Note: 4-3 Setting the Mixing Ratio of the Components (SVL-C Units) Note: 4-4 Basic Setting of the Filling Level in the Conveyor Hopper Note: Page Page Page Chapter 5: Maintenance Preparations 5-1 Maintenance Intervals Note: 5-2 Cleaning the Conveying Filter 5-3 Cleaning the Compressed Air Filter Disassembly Assembly 5-4 Adjusting the Level Probe 5-4 Troubleshooting Page Chapter 6: Technical Dat a Page Page Page SVL-A, SVL-B, SVL-C, & SVL-D Self-Contained Material Loaders - Venturi Style 40 of 49 Figure 6.4: SVL-D 6-2 Spare Parts Lists Page Page Page Page SVL-A, SVL-B, SVL-C, & SVL-D Self-Contained Material Loaders - Venturi Style 46 of 49 Figure 6.10: Take-Off Wand Assembly 6-3 Quick Start Guide SVL Self Contained Material Loader Technical Assistance