![](/images/new-backgrounds/1125132/12513213x1.webp)
STEP 1. HANGING THE CASE
Professional mounting techniques should be used. Stewart Filmscreen
Corporation cannot be liable for substandard or faulty installations.
Make sure that you mount the screen so that the electrical box is on the left side (audience left).
Installing the unit
The
The screen can be bolted directly to the support structure or suspended. If the unit is to be mounted to plaster, drywall, masonry, or other type of surface, use an appropriate fastener.
1.Install the unit onto the support structure making sure that the bottom of the case is flush with the finished ceiling.
2.Make sure the unit is level.
3.Make sure the case is not twisted or torqued lengthwise when installed. (This can cause door alignment problems and microswitch shutoff failure.)
4.Drywall or other ceiling material may be screwed directly to the ceiling flanges on the case. Refer to Figure 3.
Support Structure
Note: The two toggle switches are used by the factory only. Do not adjust.
(For proper positioning, the left switch should be flipped toward the unit, the right switch should be straight up.)
Main AC Wire
Flange
Electrical Connection
Housing
Note: Your housing may differ based on the switches used.
Trapdoor |
|
|
Figure 3: | Mask |
|
|
| |
5 |