ENGLISH | GB |
|
|
CLEANING
Each time after mowing wash off the underside of the mower deck casing with a garden hose.
If grass has dried on, remove the mower deck and scrape the underside clean.
If necessary,
CHANGING DRIVE BELT BETWEEN CENTRE BELT PULLEY AND MOW- ER DECK
1.Unhook the tension roller spring H (fig 2).
2.Unbolt the mower deck from the machine.
3.Push in the deck towards the machine.
4.Change the faulty
5.Bolt the mower deck on the attachments on the machine.
6a. Park
Hook the tension roller spring H into the floor on the
6b. Park 2000-
Hook the tension roller spring H into the fastener, just behind the front right wheel (fig 2).
When the blades are due to be sharpened, the wet grinding method with a waterstone or grindstone is to be used.
Following sharpening, the blades must be balanced to avoid vibration damage.
CHANGING BLADES
Always use original spare parts when changing the blades, blade attachments or bolts.
Always use original spare parts. Using
When changing the blades, the blades central bolt should also be replaced. It is provided with a lock- ing device. The blade bolts torque: 65 Nm.
SPARE PARTS
STIGA original spare parts and accessories are constructed exclusively for STIGA machines. Note that non original spare parts and accessories have not been checked or approved by STIGA.
Usage of such parts and accessories can influence the machines operability and safety. STIGA cannot be held responsi- ble for injuries caused by these prod- ucts.
CHANGING DRIVE BELT IN MOWER DECK
1.Remove the mower deck from the machine.
2.Remove the transmission casing over the mower deck.
3.Release the spring M which holds the tensioning roller (fig 4).
4.Change the
BLADES
Make sure the blades are always sharp. This gives the best mowing results.
SHARPENING
For safety reasons the blades must not be sharp- ened on an emery wheel. Incorrect sharpening (= high temperature) can result in the blades becom- ing brittle.
STIGA reserves the right to modify the product without prior notice.
4