Stiga 107 M, 92 M manual Introduction, Installation

ENGLISH GB

SYMBOLS

The following symbols can be found on the machine to remind you of the care and attention that are required during use.

The symbols mean:

Warning!

Read the instruction manual and the safety manual before using the machine.

Warning!

Do not insert your hands or feet under the cover when the machine is in operation.

Warning!

Watch out for discarded objects. Keep onlookers away.

Warning!

Before starting repair work, remove the spark plug cable from the spark plug.

2.Remove the locking pin and the outermost flat washer from the machine’s steering knuckle.

3.Thread one deck arm onto the steering knuckle. Place the flat washer on the steering knuckle and secure with the locking pin. Repeat on the other side (fig. 2).

4.Force the V-belt onto the machine’s pulley A (fig. 3).

5.Lift up the deck’s rear part past the catch until it drops down. When the weight of the deck is resting on the upper side of the catch, the installation is correct (fig. 4).

6.Tension the belt with belt idler B. The belt idler should be on the inside of the belt and pull out to the left (viewed from the driver’s position).

7.Screw the lift spring into the machine’s lifting arm.

(fig. 5).

8.Connect the electrical contact to the socket on the side of the machine (only applies to item no. 13-2934), (fig. 6).

INTRODUCTION

107 M

This cutting deck is available as standard in two versions:

-with mechanical setting of the cutting height (item no. 13-2930).

-with factory-fitted, electrical setting

of the cutting height (item no. 13-2934).

INSTALLATION

DECK ARMS

1.Install the left and right deck arms in the cutting deck’s front two corners. Use the existing screw and flat washer (fig. 1). Tighten the screw. After tightening, it should be possible to move the deck arms up and down.

2.Do not hook the rear part of the deck arms onto the deck yet (See “Cutting deck” point 7 below).

CUTTING DECK

1.Place the cutting deck in front of the machine. Set the maximum cutting height.

SETTING

In order for the deck to cut evenly and attractively, it has to be correctly adjusted:

1.Make sure the air pressure in the tyres is correct: Front: 0.4 bar (6 psi).

Rear: 1.2 bar (17 psi).

2.Place the machine on a level floor. Undo the screws on either side of the deck (fig. 6).

3.On the side of the deck arm are four short and two long lines. The upper long line (A) is the basic setting for a machine with 16” tyres. The lower (B) for a machine with 17” tyres (fig. 7).

Note: Villa has 16” wheels.

Depending on the length of the grass, the deck can be adjusted in various ways:

4a. Cutting normal length grass:

Adjust the deck so that the front and rear edge of the cover are the same height above the floor. This position gives the best ‘Multiclip effect’, i.e. the grass is cut up best.

4b. Cutting long grass:

Adjust the deck so that the cover’s rear edge is higher than the front edge. This position means that the deck can release the grass more easily at the rear edge.

5