ENGLISH GB

SYMBOLS

The following symbols are displayed on the ma-
chine in order to remind you about the safety pre-
cautions and attention necessary when using the
machine.
The symbols mean:
Warning!
Read the instruction book and safety man-
ual before using the machine.
Warning!
Do notput hands or feet under the cover of
the machine when it is running.
Warning!
Beware of objects being flung out. Keep
spectators away.
Warning!
Before starting any repair work, remove
the spark plug cable from the spark plug.
PREPARATIONS
Park models up to 1993:
A modification must be made to the machine in or-
der to use the mower deck.
1. Dismantle the return spring for centre steering
(fig. 1).
2. Saw off the spring bracket, level with the frame
side member (fig. 2).
3. Drill a new hole (Ø 8 mm), 8 mm from the lower
edge of the frame side member (fig. 3).
4. Fit the spring in the new hole (fig. 4).
ASSEMBLY

SUPPORT ARMS

1. Assemble the left and right support arms in the
mowing deck's front corners. Use existing screw
and flat washer (fig. 5). Tighten the screw.Do not
tighten too hard. It should be possible to move the
support arms up and down.
2. Do not hook the rear part of the support arms
into the deck yet (see “mowing deck” point 4 be-
low).

MOWING DECK

1. If the machine has the ordinary attachment fas-
teners assembled, remove them (fig. 6). The flat
washer, but not the spring clip, will be used again
(see point 3).
2. Place the mowing deck in front of the machine.
Set the highest mowing height.
3. Put one of the support arms on the machine's
front axle trunnion (fig. 7). Place the flat washer on
the axle trunnion and lock it in place with the en-
closed locking pin. Do the same thing on the other
side.
4. Lift up the rear part of the deck beyond the in-
hibitor, until it falls down. When the weight of the
deck rests on the upper side of the inhibitor, the as-
sembly is correct (fig. 8).
5. Hook the mower deck's lifting spring into the at-
tachment lift (fig. 9).

V-BELT

1. Pull the V-beltover the machine's central belt
pulley (fig. 10).
2. Tensionthe belt using the tension roller. The ten-
sion roller should be on the left of the belt seen
from the operator's position.
3a. Park -1999:
Hook the tension roller spring into the flooron the
right-hand side (fig. 10).
3b. Park 2000-
Hook the tension roller spring into the fastener,
just behind the front right wheel (fig. 10).

SETTING

For the deck to mow evenly and cleanly,it needs to
be adjusted correctly:
1. Make sure the tyre pressure is correct:
Front: 0,6 bar (9 psi).
Rear: 0,4 bar (6 psi).
2. Place the machine on a flat surface. Loosen the
screws on both sides of the mowing deck. (fig. 11).