Stiga 8211-0546-03 manual Spare Parts, Design Registration

	ENGLISH
5.3 Service position
		6 SPARE PARTS
1. Activate the parking brake.

2.Set the implement lifter in transport position.

3.Set the highest cutting height.

4.If the deck has electrical cutting height adjust- ment, disconnect the cable from the machine. See fig. 7.

5.Remove pins and washers. See fig. 2.

6.Hook the belt idler arm on the mount (8:C)

7.Force the belt off the centre pulley (8:B).

8.Grip the front edge of the deck and lift up. Lift until the deck is completely vertical and rest the rear edge on the floor. See fig. 11.

Reset in accordance with 3.1.

5.4 Cleaning

The underside of the deck must be cleaned after each use.

Set the deck in washing position.

Clean the underside of the deck carefully. Use a high-pressure washer, scraper and/or brush. When the surfaces are completely dry and clean, touch up the paintwork. Use durable yellow paint intended for metal outdoors.

STIGA genuine spare parts and accessories are de- signed specifically for STIGA machines. Please note that ‘non-genuine’ spare parts and accessories have not been checked or approved by STIGA:

The use of such parts and accessories can affect the function and safety of the machine. STIGA accepts no responsi- bility for damage or injuries caused by such products.

7 DESIGN REGISTRATION

This product or parts thereof is covered by the fol- lowing design registration:

Sweden: 66 166

Germany: 499 11 740.9

France: 577 251-253, 577 439-443

USA: 435 564

5.5 Wheels

125 Combi Pro is fitted with two lubricating cups (12:D) for the vertical shafts.

The grease nipples must be lubricated with univer- sal grease after 50 hours of operation.

5.6 Replacing blades, fig. 13

Wear protective gloves when changing blade(s) to avoid cutting yourself.

Check that the blades are always sharp. This produces the best cutting results.

Always check the blade(s) after a collision. If the blade system has been damaged, defective parts should be replaced.

Always use genuine spare parts. Non- genuine spare parts can entail a risk of injury, even if they fit the machine.

The full blade is replaced when the edges are worn.

Install the new blade with the punched text facing down.

Tightening torque: 24 Nm

5.7 Wear protection

There are two wear protection devices on the un- derside of the cutting deck to protect it. These can be replaced if necessary.

GGP reserves the right to make alterations to the product without prior notification.

21