GB | ENGLISH |
|
|
SYMBOLS
The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine.
The symbols mean:
Warning! Read the Instruction Book and Safety Manual before using the machine.
Warning! Keep spectators away. Beware of objects being flung out.
Warning! Take out the safety key before any type of maintenance is carried out.
Warning! Do not put hands or feet under the cover of the machine when it is running.
Warning! The blades continue to rotate even after the machine has been switched off.
STOP
When a red lamp lights up on the mower’s control panel and/or a sound signal is acti- vated, take out the safety key.
ASSEMBLY
When the machine was packed, it is possible that it was equipped with a lead for maintenance charg- ing. When the mower is taken out of the packag- ing, this lead is no longer required and can be removed.
dle and assemble the components. Note! Wash- er A is fitted between the screw and the plastic bushing (fig. 1).
3.Mount the upper part of the handle onto the lower part with screws, washers and locking nuts (fig. 2).
BATTERY
GENERAL
Before starting the mower for the first time and after winter storage, you should charge the battery for 1 - 2 days other- wise the battery can be damaged.
In order for the battery to maintain its capacity and to give optimum perform- ance, it is important that the charging and storage instructions are carefully fol- lowed.
•The battery used in this machine is a
•Always charge the battery indoors, in a garage, etc. where the battery is dry and protected from the weather.
•Only charge the battery when the temperature is at least 0°C and not over +40°C. Charging in lower or higher temperatures can damage the battery.
•Always keep the mower battery away from wa- ter, sources of heat (ovens, radiators, open fires, etc.) and hazardous chemicals.
•Always use the accompanying genuine Stiga charger. Never use the charger for any other product.
•Never use the charger if it is damaged in any way. A damaged lead or charger should immediately be replaced at an authorised service workshop
HANDLEBAR
1.Set the highest cutting height (position 4, see also under heading “cutting height”)
2.The components for assembling the handle’s lower part are mounted for packaging. Remove the components from the lower hole on the chassis. Then fold up the lower part of the han-
•Take care of the leads. Never carry the charger by the lead. When charging is complete pull out the plug not the lead. If an extension cable is used, use a robust sort suitable for outdoor use, even if the battery is never charged outdoors.
•The charger always feels warm to touch, during the first hours of charging.
4
