Stiga 8217-3033-01 manual Operational Faults, English, Problem, Possible cause, Remedy

GB		ENGLISH
OPERATIONAL FAULTS
Problem	Possible cause		Remedy
Motor does not start.	-	No power supply.	- Check fuses.
	-	Mains cable defective.	- Have these checked (electrician).
	-	Machine overloaded.	- Overload protection triggered Turn On-
			Off switch to “0” and let machine cool
			down.
Motor hums but does not	-	Cutting roller blocked.	- Turn On-Off switch to left, then switch
start.			machine off and remove shredding ma-
			terial. If the blockage cannot be re-
			moved immediately switch the On-Off
			switch between cutting and reverse a
			number of times until the cutting roller
			runs free.
	-	Capacitor faulty.	- Bring machine to manufacturer or au-
			thorised workshop for repair.
Shredding material is not	-	Incorrect switch position.	- Turn On-Of switch to correct position.
drawn into the shredder.	- Shredding material caught in		- Turn On-Off switch to left to release
		funnel.	shredding material, remove any dirt.
	- Shredding material to soft or		- Push down with a branch and shred.
		wet.	- Adjust shaving plate as described in
	-	Cutting roller worn.	“Adjusting the shaving plate”, replace
			cutting roller if heavily worn.
Shredding material not	-	Incorrect setting of shaving	- Adjust shaving plate, if this cannot be
cut cleanly.		plate.	adjusted it has to be replaced by the
			customer service department.
Device starts but blocks	-	Extension cable too long or	- Extension cable at least 1.5 mm², max-
under as slight load and		cross-section to small Socket	imum 25 m long. If a longer cable is
switches off via protective		too far from mains supply	used, minimum cross-section 2.5 mm².
motor switch.		and cross-section of mains
		cable too small.

8