English / USA
Replacing Starter Rope and Rewind Spring
1 |
| 1 | |
1 | 1 | KN | |
256BA075 | |||
|
| ||
| 3 2 |
| |
| 4 | 256BA032 KN | |
|
|
Replacing a Broken Starter Rope
The rewind spring may pop out and uncoil during this operation. Take care to avoid injury.
:Remove the screws (1).
:Lift away the fan housing.
:Remove the spring clip (2).
:Carefully remove the rope rotor with washer (3) and pawl (4).
5
6
256BA033 KN
:Ease the cap (5) out of the starter grip.
:Remove remaining rope from the rotor and grip.
:Tie a simple overhand knot in the new rope – see “Specifications” – and then thread it through the top of the grip and the rope bush (6).
:Refit the cap in the grip.
KN256BA034
3 2 
4
KN256BA032
:Thread the rope through the rotor and secure it with a simple overhand knot.
:Coat rope rotor bearing bore with
:Slip rotor over starter post – turn it back and forth to engage anchor loop of rewind spring.
:Refit the pawl (4).
:Fit the washer (3).
:Install spring clip (2) on starter post and engage it on the pawl's peg – the spring clip must point clockwise.
42 | FS 120, FS 120 R, FS 200, FS 200 R, FS 250, FS 250 R |