English

Replacing the starter rope

NUse a screwdriver to pry the rope out of the starter grip.

NRemove the remaining rope from the rotor and starter grip.

151BA021 KN

NThread the new rope through the starter grip and tie one of the special knots shown.

NPull the knot back into the grip.

5

217BA046 KN

NThread the rope through the top of the guide bushing (5).

NThread the rope through the rotor and secure it with a simple overhand knot.

7 KN217BA047

NCoat rope rotor bearing bore with non-resinous oil.

NSlip the rotor (6) with carrier (7) over the starter post – turn it back and forth to engage the anchor loop of the rewind spring.

217BA048 KN

NThe spring under the carrier must engage the rope rotor and the carrier (arrows).

4

4 KN217BA045

NFit the pawls (4) in the rotor and fit the washer (3) on the starter post.

NUse a screwdriver or suitable pliers to install the spring clip (2) on the starter post and engage it on the pawls' pegs – the spring clip must point clockwise as shown in the illustration.

40

MS 192 C