English / USA

6

001BA108 KN

:Pull the hand guard (6) back toward the front handle.

143BA003 KN

Wear work gloves to protect your hands from the sharp cutters.

:Fit the chain – start at the bar nose.

9 7 7

8 10

KN

 

001BA109

:Fit the guide bar over the studs (7) – cutting edges on top of bar must point to right – and engage the peg of the tensioner slide in locating hole (8) –- place the chain over sprocket (9) at the same time.

:Press down the throttle trigger interlock to release the chain brake.

:Now turn tensioning screw (10) clockwise until there is very little chain sag on the underside of the bar –- and the drive link tangs are located in the bar groove.

:Refit the sprocket cover –

and screw on the nuts only finger- tight.

:Go to “Tensioning the Saw Chain”.

Mounting the Bar and Chain

(Quick Chain Tensioner)

1

3

2

133BA026 KN

:Pull out the hinged handle (1) so that it snaps into position.

:Turn the wingnut (2) counterclock- wise until it hangs loose in the sprocket cover (3).

:Remove the sprocket cover.

30

MS 280 C