English
689BA051 KN
NFile down the depth gauge until it is level with the filing gauge.
689BA044 KN
The kickback tendency of the saw is increased if the depth gauges are too low.
689BA052 KN
NPlace the filing gauge on the chain – the highest point of the depth gauge must be level with the filing gauge.
PM1, RM2
Rear hump of the tie strap (with service marking) is lowered along with the depth gauge.
The other parts of the triple- humped tie strap and humped drive link must not be filed since this may increase the kickback tendency of the saw.
NAfter sharpening, clean the chain thoroughly, remove filings or grinding dust – lubricate the chain thoroughly.
NBefore a long
N File the top of the depth gauge |
| RSC3, RMC3, PMC3, PMMC3 |
|
| |||||
parallel to the stamped service |
| The upper part of the humped drive link |
|
| |||||
marking (see arrow) – but do not |
|
| |||||||
(with service marking) is lowered along |
|
| |||||||
lower the highest point of the depth |
|
| |||||||
with the depth gauge. |
|
|
| ||||||
gauge in this process. |
|
|
|
| |||||
|
|
|
|
|
| ||||
|
|
|
|
|
| ||||
Sharpening Tools (special accessories) |
|
|
|
| Sharpening kit 1) | ||||
Pitch |
| Round file ^ | Round file | File holder | Filing gauge | Flat file | |||
inch | (mm) | mm | (inch) | Part No. |
| Part No. | Part No. | Part No. | Part No. |
1/4 | (6,35) | 4,0 | (5/32) | 5605 772 4006 | 5605 750 4327 | 1110 893 4000 | 0814 252 3356 | 5605 007 1027 | |
3/8 P | (9,32) | 4,0 | (5/32) | 5605 772 4006 | 5605 750 4327 | 1110 893 4000 | 0814 252 3356 | 5605 007 1027 | |
0.325 | (8,25) | 4,8 | (3/16) | 5605 772 4806 | 5605 750 4328 | 1110 893 4000 | 0814 252 3356 | 5605 007 1028 | |
3/8 | (9,32) | 5,2 | (13/64) | 5605 772 5206 | 5605 750 4329 | 1110 893 4000 | 0814 252 3356 | 5605 007 1029 | |
0.404 | (10,26) | 5,5 | (7/32) | 5605 772 5506 | 5605 750 4330 | 1106 893 4000 | 0814 252 3356 | 5605 007 1030 | |
1)consisting of file holder with round file, flat file and filing gauge
48 | MS 362 C |