Stow manual Stow MS-93 PLASTER/MORTAR Mixer General Information, Engine Maintenance

STOW MS-93 PLASTER/MORTAR MIXER — GENERAL INFORMATION

Application

The STOW MS-93 series mixers (drum capacity of 9.0 cu. ft./263 liters) are shipped completely assembled and have been factory tested and are ready for use.

This mixer is only intended for the production of plaster and mortar. The mixer must be used for its intended purpose and is not suitable for the mixing of flammable or explosive substances. The mixer must not be used in an explosive atmosphere.This mixer has a batch capacity between 2-1/2 and 3-1/2 bags.

Power Plants

The STOW plaster and mortar mixer can be powered by either a Honda GX240K1HA2 air-cooled, 4-stroke gasoline engine or a 2 HP electric motor. Refer to Table 2 for specific engine or electric motor data information.

Electrical

If mixer is equipped with an electric motor, make sure that the power being supplied to the motor corresponds to the voltage rating label on the motor. Supplying the wrong volt- age to the electric motor will cause severe electrical damage to the motor.

Always make sure the OFF/ON switch on the electric motor is in the OFF position before applying power.

It is strongly recommended when inserting the mixer's power cord into a receptacle, that a G.F.C.I. (Ground Fault Current Interrupter) receptacle be used (115 VAC applica- tions).

Extension Cables

The extension cable should be a 3-wire configuration that includes a ground wire that conforms to UL code. The wire cross section must be a minimum of 2.5 mm2. Choose an extension cord of adequate current carrying capacity as referenced in Table 6. Remember cable distance affects the current-voltage capacity of the extension cable.

Ensure that the extension cable is carefully laid out avoiding

wet areas, sharp edges and locations where vehicles might

run over it. Avoid allowing the extension cable to be trapped underneath the mixer.

Unroll the extension cable fully or it will overheat and could

catch fire. Make sure that all extension cable connections are

dry and safe. Replace any defective or badly worn extension cable immediately.

Hardware

Check all hardware on the mixer before starting. Periodically inspect all hardware. Loose hardware can contribute to early component failure and poor performance. Use Table 4 as general guideline when torqueing of mixer hardware is required. Remember to keep all mixer hardware compo- nents tight.

Table 4. Hardware Torque

Recommendations

Hardware	Torque (ft-lbs)
Diameter
5/16-inch x 18	14
3/8-inch x 16	24
3/8-inch x 24	37
1/2-inch x 13	39
1/2-inch x 13	90
(Grade 8)

Engine Maintenance

For basic engine maintenance, refer to the engine mainte- nance section in this manual. For a more detailed engine maintenance, refer to the Honda Engine Owner's manual furnished with the engine.

STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10) — PAGE 15