I N S TA L L AT I O N
S p e a k e r W i r i n g
Locate the hardware pack supplied with your new component set. Inside you will find screws and crimp terminals.
The midrange and midbass speakers are each equipped with a small and a large terminal. The large terminal is the positive (+) connection and the small terminal is the negative
Find the corresponding female crimps in the hardware pack. Properly crimp these connectors to the end of your chosen speaker wire. Attach the speaker wire to the terminals on the speakers. Mount the speaker into its proper location.
C o n n e c t i n g W i r e s To T h e C r o s s o v e r
Attach the ends of the speaker wires to the corresponding screw terminals on the supplied passive crossovers. Refer to the following drawings on pages 10 and 11 to assist in these connections.
Attach the wires from the tweeter to the crossover observing proper polarity. Note that the crossover has three screws for the tweeter connection. The extra terminal provides a choice of 2 dB of attenuation. Attenuation of the tweeter output (reduced level) may be desirable when the tweeters need to be mounted close to the listening position or when mounted close to glass or other reflective surfaces. Attach the negative tweeter wire to the screw terminal labeled
Attach the wires from the midrange speaker to the corresponding screw terminals on the crossover
Attach the wires from the midbass speaker to the screw terminals designated "Woofer" on the crossover again observing speaker polarity.
The two remaining screw terminals on the crossover are the inputs. Attach the speaker wires from the outputs of your amplifier here observing proper polarity.
9
R E T U R N T O C O N T E N T S
