6
The importance of the
installation of your Sub-Zero
cannot be overemphasized. The
proper installation of your unit is
the responsibility of the selling
dealer or installer. Any questions
or problems pertaining to the
installation should be directed to
the selling dealer

sing your sub-Zero

U

sing your sub-Zero

Your new refrigerator and/or
freezer was thoroughly inspected
and tested before it was shipped
from the Sub-Zero factory.
During these procedures, the
temperatures were preset to
maintain approximately
38°F(3°C) in the refrigerator
section and approximately 0°F
(-18°C) in the freezer section
(except 249R). If you wish to
make temperature adjustments,
simply turn the control knob so
the indicator lines up with the
desired number.
The higher the number the
colder the temperature (#1 is the
warmest and #7 is the coldest
setting).
For the location of the control,
refer to the model of your Sub-
Zero on pages 4 and 5.
You should be aware it is normal
for these temperatures to
fluctuate slightly, depending on
external influence such as: open
door for extended periods, the
degree of humidity present and
room temperature.
Model 245
The freezer control is located on
the back wall above and right of
the icemaker assembly. The
refrigerator control is situated
left of center at the top of the
refrigerator compartment (see
Model 245 on page 4).
Model 249R
(Manual Defrost)
The control is situated on the
right hand side of the back wall
in the upper freezer com-
partment (see Model 249R on
page 4).
Model 249RP
The control is located on the
right side of the back wall just
below the lower shelf assembly
(see Model 249RP on page 5).
Model 249FF
The control is found at the top of
the freezer on the right side of
the defrost blower assembly (see
Model 249FF on page 5).

Temperature

Controls

200 Use & Care Guide 3758377 1-04.qxd 1/2/2004 1:04 PM Page 6