TROUBLESHOOTING
Troubleshooting
SERVICE INDICATOR
‘SERVICE’ flashes in control panel display.
tVerify condenser is clean.
tTurn unit off at the control panel, then on. If indicator continues to flash, contact
UNIT OPERATION
No lights or cooling.
tVerify power is on.
tVerify electrical power to unit and home circuit breaker is on.
No lights.
tDoor may have been left ajar which has disabled lights to eliminate excess heat. If lights are out, close door for one hour. If lights are still out, contact
tCabinet lighting must be replaced by
Condensation forms inside unit.
tVerify condenser is clean.
tVerify door is closing properly.
tVerify door has not been left ajar.
tVerify door gasket does not have rips or tears. If it does, contact
High temperatures, unit runs excessively or unit giving off too much heat.
tVerify condenser is clean.
tVerify door is closing properly.
tVerify door has not been left ajar.
tIncreased ambient temperatures may cause compres- sors to run longer.
tIf temperature display shows 45° and 55°, but is not cooling, unit may be in showroom mode. Contact
ODOR
tUnit should be cleaned before using for the first time. This will clear any odors that may have been trapped during shipping.
SERVICE
tMaintain the quality built into your product by contacting
tWhen contacting service, you will need the model and serial number of your unit. Both numbers are listed on the product rating plate. Refer to page 4 for rating plate location.
tFor warranty purposes, you will also need the date of installation and name of your authorized
10
