Summit FF28L Installation Instructions, Before Using Your Refrigerator, Electrical Connection

Models: FF28L

1 12
Download 12 pages 48.35 Kb
Page 5
Image 5
INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

Before Using Your Refrigerator

Remove the exterior and interior packing.

Check to be sure you have all of the following parts: Instruction manual

2 refrigerator shelves

Before connecting the refrigerator to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

Installation of Your Refrigerator

This appliance is designed to be free-standing only, and should not be recessed or built-in.

Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully loaded. To level your refrigerator, adjust the leg at the front of the refrigerator.

Allow 5 inches of space at the back and sides of the refrigerator, which allows the proper air circulation to cool the compressor.

Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold ambient temperatures may also cause the refrigerator not to perform properly.

Avoid locating the refrigerator in moist areas.

After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing food into the refrigerator.

When installing the unit on a table or countertop, keep the following in mind:

Surface (countertop) is flat, level, and strong enough to support the unit once it is fully loaded.

Surface is wide enough to accommodate the unit without any overhang.

Surface is deep enough to accommodate the unit when the door is opened to 90º.

Electrical Connection

Warning

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized service center.

Plug the refrigerator into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center.

4

Page 5
Image 5
Summit FF28L Installation Instructions, Before Using Your Refrigerator, Installation of Your Refrigerator, Warning