Sunbeam 1626 instruction manual Night Light Feature, Storage, MAINTENANCE, Care and Cleaning

WALL MOUNT	HAIR DRYER	REMOVABLE
		LINT SCREEN

BRACKET

SCREW

NIGHT LIGHT FEATURE

To change bulbs,

follow instructions below.

		110V-120V
		POWER
		SUPPLY
BRACKET	SCREW	RELEASE
		BUTTON

LOCKING PLATE

STANDARD ON MODEL 001626-040-0003-FT. POWER CORD

OPTIONAL ON MODEL 001626-020-000

OFF

BUTTON

HIGH

MED

LOW

ON SWITCH

BUTTON

6-FT. POWER CORD

NIGHT

LIGHT

TOP HOUSING OF

WALL MOUNT

STORAGE

1.Always store dryer inside the base.

2.Do not mount or store dryer in an area with excessive heat or moisture.

3.Do not wrap cord around dryer. Allow to hang loosely from dryer.

4.Do not hang dryer by cord or use cord as a handle.

5.Store in a cool, dry place and out of reach of children.

6.Store where dryer will not be accidentally damaged from bumping or falling. Do not put anything on top of dryer.

MAINTENANCE, CARE AND CLEANING

1.Always unplug dryer from outlet before cleaning.

2.Clean dryer by wiping with a soft, lightly moistened cloth.

3.NEVER PUT HAIR DRYER IN WATER.

4.The motor never needs oil or grease.

5.Check the removable lint screen. It is important that you clean the removable lint screen when hair, lint or dust begin to build up on it. To remove the screen, rotate counter-clockwise and loosen. To clean, brush the outside of the screen with a toothbrush to loosen lint, etc. Then turn the screen over and rinse under a running faucet. Towel dry the screen thoroughly. If inside of screen is dirty, brush gently with a toothbrush to clean. To replace screen, line up pegs on inside of the screen with slots on side of unit and rotate clockwise to lock in place.

1.To remove lens:

Insert tool (screw driver, knife point, etc.) in crevice to flex tabs.

2. Replace bulb and lamp holder as an assembly by pulling straight out. Each bulb can be replaced separately.

6 7