TOFILL THE WATERRESERVOIR
1. Make sure the iron is unplugged. Set the Steam Lever to
O
/Off (Dry) and the
Fabric Select Slideto OFF.
2. Lift the Water Fill Hole Cover.
3. Fill water cup with water. Pour water into iron water reservoir. Donot fill water
reservoir beyond maximum fill level.
W
ARNING
:
To prevent the risk of burns, be careful when filling a hot iron with water.
Hot metalparts, hot water and steam can cause injuries.
DRY IRONING
1. Make sure the Steam Lever is turned to the
O
/Off (Dry) setting.
2. Plug the cord into a 120-Volt AC outlet.
3. Select the fabric setting you desire using the slide (Silk or Synthetics).Allow the iron
to heat for 2 minutes. Whilethe iron is heating, make sure it is sitting on its heel rest
on astable, protected surface.
N
OTE
:
While the Steam Lever is turned to the
O
/Off (Dry) setting, you may still use
the SHOT OFSTEAM
®
or SPRAYMIST
®
feature. Please make sure the water reservoir
is 1/4full of water.
T
IP
:
Refer to the Ironing Guide for the recommended setting foryour fabric.
STEAM IRONING
1. Make sure the Steam Lever is turned to the
O
/Off (Dry) setting.(This Step is not
necessary for Irons with the Drip Free™ feature)
2. Follow the instructions for “Filling the Water Reservoir”.
3. Plug the cord into a 120-Volt AC outlet.
4. Select the fabric setting you desire using the slide (Synthetic, Silk, Linen,
Cotton or Wool). Allow the iron to heat for 2 minutes. While the iron is heating,
make sureit is sitting on its heel rest on a stable, protected surface.
5. Allow the iron to heat for 2 minutes, and then turn the Steam lever to the appropriate
setting.
T
IP
:
Refer to the Ironing Guide for the recommended setting for your fabric.
I
MPORTANT
:
When not ironing, always set the Steam Lever to
O
/Off (Dry) and the
Fabric Slide toOFF.