Sunbeam 3982 warranty HOW to USE the Special Functions, Spray Mist, Auto-Off

STEAM IRONING

1.Make sure the Steam dial is turned to the Dry/O setting.

2.Follow the instructions for “Filling the Water Reservoir” on Page English-3.

3.Plug the cord into a 120-Volt AC outlet.

4.Turn the large Fabric/Temperature dial to the fabric setting you desire (Synthetic, Silk, Linen, Cotton or Wool). Allow the iron to heat for 2 minutes. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface.

5.Allow the iron to heat for 2 minutes and then turn the Steam dial to the appropriate setting.

TIP: Refer to the Ironing Guide on Page English-7 for the recommended setting for your fabric.

HOW TO USE THE SPECIAL FUNCTIONS

SPRAY MIST®

The SPRAY MIST® feature dampens the fabric to aid in removing wrinkles from heavy fabrics and for setting creases. To use the SPRAY MIST® feature: Pump the SPRAY MIST® button (may require several pumps to prime the water pump).

AUTO-OFF

After 30 minutes, the power indicator light will go out. This indicates that the iron is no longer heating.

To restart the iron, unplug the power cord and plug it back in. If you do NOT want to iron any longer, unplug the iron. Then turn the small Steam dial to Dry/O and the

large Fabric/Temperature dial to Off/O.

WARNING: Auto-Off is a safety feature and is not a recommended means for turning your iron off. See “Caring for Your Iron After Use” on Page English-5.

English-4