Sunbeam 4211 NEVER yank the power cord when unplugging, the, damage, can, the iron. This, cord.

To reset the iron:
Move the iron back and forth and allow it to reheat for 2 minutes. The indicator will stop
blinking and the iron will start heating again.
WARNING: The patented MOTION SMART®Auto-Off is a safety feature, not a recommended
means for turning your iron off. See “Caring for Your Iron After Use” for information on
turning off your iron and storing it safely between use.
ANTI-CALCIUM SYSTEM (select models only)
The Anti-Calcium System is a permanent system located inside the water reservoir.
This system removes calcium from the water and reduces calcium build-up on the soleplate.
RETRACTABLE CORD SECTION(select models only)
1. When winding the cord, hold the plug with one hand, and press the winding button
with the other hand. (Failure to hold plug may cause plug to fly.)
2.
The cord reel is compact for multi-layer winding of the cord. In case cord is not fully rewound,
pull out the cord and steer cord evenly on the reel.
3. In case the cord is not pulled out easily, pull cord firmly.
4. Select the amount of cord desired before plugging into an electrical outlet.
5. Do not allow children to use retractable cord feature as the cord may cause injury.
CARING FOR YOUR IRON AFTER USE
TURNING OFF YOUR IRON
1. Turn the Steam Lever to O /Off (Dry) and Fabric Select Dial to Off.
2. Unplug the iron from the power source.
WARNING:
NEVER yank the power cord when unplugging the iron. This can damage the cord.
STORING YOUR IRON
1. Allow the iron to cool.
2. If you do not use your iron on a daily basis, empty the water reservoir after each use for
a longer iron life. To do so, unplug the iron, turn the iron upside down, open the fill hole
cover, and allow water to flow from the fill hole. Shake the iron gently to remove trapped
water drops.
3. On corded models only: Loosely loop the power cord around the heel rest and store the
I MPORTANT : Wrapping the cord around the iron tootightly can damage the cord.
T IP : When not ironing, always set the Steam Lever to O /Off (Dry) and the Fabric Select Dial
to Off.
the iron on its heel rest.