Sunbeam 9100030005498 manual Setmodedesired, Set Humidity, Trouble Shooting, Mode Button, up down

P/N:BCM5555CN/BCM7305RCBCN08EFQSG1/129857/9100030005498 size: 8.5 inch (W) X 11 inch (H)

-4-C printing

-95gsm matt coated paper

-Double-sided printing (English Front / French Back)-2-fold lea￿et (fold 2 times, English to outside)

Displays room humidity when

humidi￿er is plugged in and after setting mode, humidity or timer.

1.SETMODEDESIRED

MODE BUTTON

OFF (OF) HIGH HUMIDITY (3)

MED HUMIDITY (2) LOW HUMIDITY (1)

PROVIDES CONTINUOUS

HUMIDITY OUTPUT

Humidity cannot be setin High, Med or Low settingAUTO HIGH HUMIDITY (A3)

AUTO MED HUMIDITY (A2)

AUTO LOW HUMIDITY (A1)AUTOMATICALLY

MAINTAINS SET HUMIDITY

(Go to step 2 SET HUMIDITY)

MODE/OFF BUTTON

Push twice to select Mode;

Hold to turn O￿

SET TIMER AUTOMATICALLY TURNS HUMIDIFIER ON/OFF

2.SET HUMIDITY

ARROW BUTTONS

in A3 (AUTO HIGH), A2 (AUTO MED) & A1 (AUTO LOW) ONLY

up downDefault SET HUMIDITY may be less than

Room Humidity. Humidi￿er will not operate in AUTO MODE if the SET HUMIDITY is less than Room Humidity, adjust as required.

AUTOMATICALLY CYCLES ON/OFF TO MAINTAIN SET HUMIDITY!

In (A3), (A2) & (A1) ModeTIMER LIGHTIIIuminates when

Timer is set

Press & Hold BOTH ARROW BUTTONS for 2 SECONDS until 00 blinks.

Then using one arrow select desired time (1 hour increments).

TROUBLE SHOOTING

MIST OUTPUT IS MINIMAL TO NONE

Reason: This humidi￿er provides a cool, invisible moisture.

It is normal not to see mist.

Solution: Refer to Mode Button section to adjust humidity.

HUMIDIFIER RUN TIME VARIES BETWEEN USES

Reason: Run time for this humidi￿er is based on average room condition and can be a￿ected by temperature, humidity level, room construction, and air exchange.

Solution: To extend run time, use the Auto mode and set your desired humidity level.

HUMIDIFIER HUMIDITY DOES NOT MATCH ROOM HUMIDITY

Reason: The humidi￿er can only sense/obtain the humidify level near the humidi￿er. Actual room humidity may be slightly di￿erent.

Solution: Place humidi￿er in center of room for better circulation.

HUMIDIFIER CONTINUOUSLY DISPLAYS 21%

Reason: Humidity at the humidi￿er is at or below 21%

Solution: Continue to operate humidi￿er to raise the room humidity.

HUMIDIFIER CONTINUOUSLY DISPLAYS 90%

Reason: Humidity at the humidi￿er is at or above 90%

Solution: Stop operating the humidi￿er if the humidity level is too high.

If you’re still having trouble –	1
	800
Do not return product to store!
	253
Please call:
	2764

©2008 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. P.N. 129857 / BCM5555CN/BCM7305RCBCN08EFQSG1/9100030005498