Using your Professional Straightener.

Using Your Professional Straightener

1.Insert the plug into the power outlet and turn the power on. The red light will illuminate to indicate that the straightener is connected to the power outlet and the power is turned on. Switch the on/off switch to on (1). The green light will illuminate to indicate that the unit is switched on and heating.

2.Allow the straightener to heat for 2 minutes before using.

3.Ensure hair is completely dry. Brush your hair thoroughly.

4.Separate out a section of hair approximately 4cm in width and smooth it with a comb.

5.For best results, start at the scalp and work to the ends of the hair. Place the separated section of hair between the flat plates and close the handle gently around the hair.

6.Hold the styler in position for 3 to 5 seconds, depending on the type of hair (3 seconds for fine hair and up to 5 seconds for thicker or curlier hair).

7.Once the hair is heated carefully slide the styler along the section of separated hair, making sure that the hair is heated and straightened all the way to the ends.

8.Select another section of hair and repeat the process. Continue until all of the hair has been straightened.

9.Once straightening is complete, switch the unit off (0) and remove the plug from the power outlet. Allow to cool completely before storing.

Care and Cleaning.

After use, switch the on/off switch to the off position (O), remove the plug from the power outlet and allow the styler to cool before storing.

To clean the plates, wipe with a soft cloth moistened with a solution consisting of a small amount of hair shampoo in warm water. Wipe the outside of the styler with a damp cloth, and dry with a soft cloth.

Do not wrap the cord around the styler when not in use. Store in a dry place.

Sunbeam is a registered trademark. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this leaflet. Approved by the appropriate Electrical Regulatory Authorities. Backed by Sunbeam‘s 3 Year Replacement Guarantee and National Service Network.

© Copyright. SUNBEAM CORPORATION LIMITED 2001. (INCORPORATED IN N.S.W.) A.C.N. 000 006 771

For more information or advice on any Sunbeam products, contact the Sunbeam Consumer Service Line on 1800 025 059 in Australia. In New Zealand - contact the Sunbeam Office in Auckland on 09 912 0747.

3

Page 4
Image 4
Sunbeam HS9200 manual Using your Professional Straightener, Care and Cleaning