Using your Styler
Ceramic Heater
Your hairstyler has a ceramic heater. This can be seen working by the high intensity red indicator light. The light comes on to show it is working and remains static for a few seconds. It then flashes rapidly and when the maximum temperature is reached the light will slow to a steady flash.
If the styler is being used on a high heat setting and you switch to a lower setting, the light will go out until the plate temperature reduces. It will then work as normal.
•Before you start to style your hair, comb through so that there are no tangles.
•For best results, hair must be completely dry.
•Plug in to a suitable supply and switch the unit on. The neon light will come on.
•There is no need to pre heat the styler. The styler will get very hot very quickly so do not touch the plates with your fingers.
•Use the variable heat control to adjust the heat to suit your hair type. Turn the dial clockwise to increase the heat and anticlockwise to decrease. Use a lower heat on young or fine hair and a higher temperature on thick or curly hair.
•The maximum temperature reached is 200 degrees and the minimum is 150 degrees.
•Apply a styling lotion. We recommend PPS professional products.
•Beginning at the back, use clips to section the hair. Take a section approximately 5cms wide and comb or brush it through. Working from root to the ends, place the section between the plates and squeeze the handle shut. Be careful not to touch your skin.
•Hold the styler in place for 3 to 5 seconds depending on your hair type (3 seconds for fine hair and up to 5 seconds for thicker hair).
6
