Sunbeam KE3560 Using your Quantum Kettle, Before using your kettle, Operation of your kettle

Using your Quantum Kettle

Before using your kettle.

It is recommended that you clean your kettle before use by boiling a full kettle of water then discarding the water.

Operation of your kettle

1.To fill the kettle, remove it from the power base and lift the lid. Fill with the desired amount of water. Alternatively, the kettle may be filled through the spout. Always fill the kettle between the minimum and maximum marks. Too little water will result in the kettle switching off before the water has boiled.

NOTE: Do not fill the kettle over the maximum level, as water may spill out of the spout when boiling. Ensure that the lid is firmly in place before placing the kettle on the power base.

2.Connect the plug into 230/240 Volt AC power outlet. Turn the power ON.

3.Position the kettle on the power base. Press the ON/OFF button on the handgrip. The power indicator light will light up. The kettle will switch off automatically once the water has boiled.

NOTE: Ensure that the ON/OFF switch is clear of obstructions and the lid is firmly closed. The kettle will not turn off if the switch is constrained or if the lid is left open. Do not remove the kettle from the power base, while in use.

4.Lift the kettle from the power base and pour the water.

NOTE: Use caution when pouring the water from your kettle, as boiling water will scald.

5.The kettle may be stored on the power base when not in use. The kettle will not re-boil until the ON/OFF switch is pressed downward.

NOTE: Ensure the power is turned OFF at the power outlet while the kettle is not in use.

Should you accidentally allow the kettle to operate without water, the boil-dry protection will automatically switch it off. If this should occur, allow the kettle to cool before filling with cold water and re- boiling.

Cord Storage Facility

Excess cord can be stored by feeding the cord into the Storage Cavity underneath the Power Base.

360° power base

6