Using your Dome Stainless
Before using your kettle.
Fill the kettle with water up to the maximum level indicator, boil and discard.
Using your kettle.
1.To fill the kettle with the desired amount of water (minimum 1 cup/250ml) you can either:
•fill the kettle through the large spout, or
•remove the lid by holding the cool touch knob firmly and pulling out.
NOTE: Do not fill above the maximum level indicator (marked on the water gauge as “MAX”) as water may spill out of the spout when boiling.
2.If you filled the kettle by removing the lid, replace the lid by positioning it on top of the kettle and pressing firmly until it locks into position.
3.Place the kettle on the power base and connect the plug into a 230/240 Volt AC power outlet. Turn the power ON.
4.Press the ON/OFF switch downwards. The light will illuminate to indicate the kettle is heating.
Note: Do not remove the lid while the kettle is in use.
5.The kettle will switch off automatically once the water has boiled.
Note: Ensure that the ON/OFF switch is clear of obstructions. The kettle will not turn off if the ON/OFF switch is constrained. Do not remove the kettle from the power base while in use.
6.Lift the kettle from the power base and pour the water.
7.The kettle may be stored on the power base while not in use. The kettle will not
Note: Ensure the power is turned off at the power outlet when the kettle is not in use. Should you accidentally allow the kettle to operate without water, it will cut out for
Cord Storage Facility.
Excess cord can be stored by winding the cord around the storage facility underneath the power base.
360° power base
4