Sunbeam KE7500 manual Using your Alur Stainless, Before using your kettle, Dual-use switch

Using your Alur Stainless

Before using your kettle.

Fill the kettle with water up to the maximum level indicator, boil and discard.

Dual-use switch.

This kettle features a dual function switch. Push the upper section of the switch ‘ ’ to turn the kettle ‘On’. Push the lower section of the switch ‘ ‘ to pop open the lid.

Dual use switch

Power

Open lid

5.Press the ON ‘ ’ switch. The light will illuminate to indicate the kettle is heating.

6.The kettle will switch off automatically once the water has boiled.

Note: Do not remove the kettle from the power base while in use.

7.Lift the kettle from the power base and pour the water.

8.The kettle may be stored on the power base while not in use. The kettle will not re-boil until the ON switch is pressed. Note: Ensure the power is turned off at the power outlet when the kettle is not in use. Should you accidentally allow the kettle to operate without water, it will cut out for boil-dry protection. If this occurs, allow the kettle to cool before filling with cold water and re-boiling.

Cord Storage Facility.

Excess cord can be stored by winding the cord around the storage facility underneath the power base.

Using your kettle.

1.Push down the lower section of the switch ‘‘to open the hinged locking lid.

2.Fill the kettle with the desired amount of water (minimum 1 cup / 250ml).

NOTE: Do not fill above the maximum level

indicator (marked on the water gauge as 360° power base “MAX”) as water may spill out of the

spout when boiling.

Alternatively, the kettle may be filled through the pouring spout.

3.Push the lid closed firmly until it locks into position.

4.Place the kettle on the power base and connect the plug into a 230/240 Volt AC power outlet. Turn the power ON.

4