Using your Sunbeam Kettle
Before using your kettle
It is recommended that you clean your kettle before first use by filling the kettle with water, up to the maximum level indicator, boil and discard.
Using your kettle
1.To fill the kettle, remove it from the power base. Remove the lid by turning it anti clockwise.
2.Fill the kettle with the desired amount of water. Always fill the kettle between the minimum and maximum marks.
NOTE: Do not fill the kettle over the maximum level, as water may spill out of the spout when boiling.
3.Replace the lid and lock it into place by turning it clockwise. Ensure the filter is facing the front of the kettle and in line with the tip of the spout.
NOTE: The lid is not locked into place if the filter is not facing the front of the kettle and in line with the tip of the spout
4.Place the kettle on the power base. Connect the plug into a 230/240 Volt AC power outlet. Turn the power ON.
5.Touch the Power/Boil button. The button lever will illuminate to indicate the kettle is heating. The kettle will switch off automatically once the water has boiled.
IMPORTANT: Ensure that the lid is firmly in place.
NOTE: Boiling can be interupted or cancelled at any time simply by lifting the kettle from the power base or pressing the button.
6.Lift the kettle from the power base and pour the water.
NOTE: Use caution when pouring the water from your kettle, as boiling water will scald.
7.The kettle may be stored on the power base while not in use.
NOTE: Ensure the power is turned off at the power outlet when the kettle is not in use.
Should you accidentally allow the kettle to operate without water,
Cord Storage Facility
Excess cord can be stored by winding up the desired length of cord into the storage facility inside the power base.
4
