Sunbeam SL5200 manual Using your SlushMagic, Maximum fill indicator disk

Using your SlushMagic

1.Turn SlushMagic to the ‘off’ setting on the side switch.

2.Plug the unit into a 230 -240 volt AC power outlet and switch the power on.

3.Secure the lid on to the Slushie jug. Place the front end on first, then secure the locking latch onto the rear clip of the canister. See Figure 4.

7.Add another 8 -10 standard size ice cubes through the lid opening until the ice reaches the maximum fill indictor disk on the inside of the canister, then add another capful of rock salt.

Important: Do not overfill above the maximum fill indictor disk with ice and rock salt. See Figure 5.

Figure 4

4.Turn the side switch to ‘on’. The inner and outer paddles will start to rotate.

5.Slowly pour the chilled drink mixture into the rear section of the lid. You will see the drink mixture through the jug being churned by the paddles.

Important: Diet or reduced sugar softdrinks will not work in SlushMagic.

Important: Do not place more than 1 litre (to the MAX line) of drink mixture in SlushMagic.

6.To fill the inside of the canister, remove the cap from the lid and add ice cubes through the lid opening to half fill the canister (this will take about 8 -10 standard size ice cubes). When the canister is half full of ice, turn the cap upside down and fill with rock salt. Add the rock salt to the ice.

Note: Regular square ice cubes work best in SlushMagic.

Maximum fill indicator disk Figure 5

8.Pour ¼ cup (60ml) of water over the top of the rock salt and ice.

9.Place the cap back on the lid.

10.Leave the unit running for 10 to 15

minutes, depending on the desired ‘slushie’ consistency.

Note: A warmer room temperature may increase this time.

11.After 5-7 minutes check the ice and rock salt mixture through the lid opening. If the ice has melted, add a few more ice cubes and ½ capful of rock salt at a time.

Important: Do not fill to the top of the canister with ice and rock salt.

5