Sunbeam WF5700 Before using your Sunbeam Pure Source Water Filter System, Inserting the filter

Models: WF5700

1 7
Download 7 pages 47.95 Kb
Page 5
Image 5

Using your Pure Source Water Filter System.

Before using your Sunbeam Pure Source Water Filter System.

Carefully unpack the appliance and check that all components listed are included.

Wash the water jug and lid with warm soapy water then rinse thoroughly and dry.

Wipe the appliance over with a clean cloth or paper towel.

Do not wipe the base with a used kitchen cloth, because you could contaminate it with bacteria

Inserting the filter.

Remove the two red plugs from the new filter tubes and make sure the black O-rings are pushed into place on the tubes.

Place the appliance on a flat level surface with the rear of the unit facing you.

With the two filter tubes at the top, insert the filter into the cavity and push inward and upward. The filter is firmly secured when you hear a soft snap sound.

Plug the appliance into the electrical outlet and turn the power on.

Push the reset switch to activate the Electronic Safety Monitor.

Preparing to flush the filter.

Remove the water jug from the base and fill with water. Place the full jug back on the base so that it stands flat.

Place a large container or jug (at lease 2.75 litres) under the spout on the left side (just above the grey manual water dispenser).

Flushing the filter .

The first couple of jugs of filtered water may contain some black dust released from the carbon filter. Although this is not harmful, we recommend that you flush the filter twice and discard both batches of filtered water.

Push the Auto-Flow button (Shown in Figure 2) and the entire contents of the water jug will be filtered and dispensed into the container placed under the spout. The appliance will

automatically shut off when the jug is empty. It is normal for a small amount of unfiltered water to remain in the bottom of the water jug.

Note: During the flushing process, the appliance may splutter as the air inside the filter is replaced by water. You will notice a change in the filtering noise when the water jug is almost empty.

Figure 2

Filtering water.

For manual dispense, place a glass or jug under the spout and push it against the manual water dispenser button. To filter the entire contents of the water jug, place a large container or jug (at lease 2.75 litres) under the spout. Press the Auto-Flow button. The appliance will automatically shut off when the jug is empty.

Filter life.

The life of the filter is approximately 750 litres. However, your filter may need replacing more regularly, depending on frequency of use and the quality of your tap water. If you notice that the water begins to flow very slowly from the spout it is time to change the filter.

The Electronic Safety Monitor light will begin to flash approximately 30 litres before the filter requires changing. When the filter requires changing the appliance will automatically shut off until the filter is replaced and the reset button is pressed.

Page 5
Image 5
Sunbeam WF5700 manual Before using your Sunbeam Pure Source Water Filter System, Inserting the filter, Flushing the filter