Using your heater
HE2300 Oscillating Twinheat Ceramic Heater
1.Place the heater on a flat level surface and ensure that the air intake and outlet are clear of obstructions.
2.Insert the plug into a 230/240V power outlet and turn the power on.
3.Turn the thermostat dial to the highest setting by rotating the dial clockwise as far as it will turn.
4.Turn the mode dial to the desired heat setting, I or II.
5.To use the fan without heat, set the thermostat dial to the lowest setting and select the fan setting on the mode selector dial.
Setting the thermostat
1.Set the thermostat to the highest setting by turning the dial clockwise as far as it will turn.
2.When the room has reached the desired temperature level, lower the thermostat setting by turning the thermostat dial anti- clockwise until it clicks. The heater will stop operating.
3.The thermostat is now set and will automatically maintain the
Note: When set to the high setting it is normal for the heater to cycle between high and low as it maintains the preset temperature. The heat output does not vary when the heater is set to the low heat setting (I). To prevent the unit from cycling, raise the thermostat setting.
Adjusting the swivel housing
The revolutionary vertical twin housing allows heat to travel in two different directions for maximum heat distribution.
Carefully rotate each housing to direct the airflow in the desired direction. Do not swivel the unit beyond the point of resistance.
Using the Oscillation Function
The 70 degree oscillation function can be used on any setting.
1.Press the oscillation button (OSC), positioned on the top of the heater. The heater will begin to oscillate from side to side.
2.To stop the heater from oscillating, simply press the (OSC) button once again.
