Sundance Spas Portofino Series

•Air Controls/Massage Selectors: 3/1

• Filter: 2-Stage MicroCleanTM Cartridge, 20” SlipstreamTM Weir

with Automatic BrominatorTM

•Water Treatment: Brominator Chemical Feeder; Ready for

PermaClearTM or SunZoneTM CD Installation

• Lighting: Underwater, with Two Colored Lenses; Optional

SunGlowTM Multi-Color LED Light Kit

• Handrail: 1 High Quality Stainless Steel, 1 Integral

• Pillows: 2-Part/2-Tone Gray, Bolt-on; Optional Blue or Camel

Insert

•Heater:

-US/Canada Convertible Model (60 Hz): Low Flow, 1 kW @

120 VAC or 4 kW @ 240 VAC

-Export Model (50 Hz/60 Hz): Low Flow, 2.7 kW @

230-240 VAC

•Electrical Requirements:

-US/Canada Convertible Model (60 Hz): 120 VAC @ 15 A or 240

VAC @ 25 A or 40 A

-Export Model (50 Hz / 60 Hz): 230 - 240 VAC @ 20 A or 30 A; or

suitably rated circuit breaker to comply with local electrical

regulations. Certain countries may require dual power in-

puts; two 16 A breakers are required for this configuration.

D.A.L./11.20.03

Contents

Main Attention New Spa Owner! Table of Contents OH....................................................... SN1............................................................. - - - - ICE.............................................................. COL ............................................................ 1.0 Important Spa Owners Information Refer to section 4.0-4.2 (page 5-6). 2.0 FCC Notice 3.0 Important Safety Instructions Refer to section 6.0 (page 8). Page 3.1 General Electrical Safety Instructions 4.0 Choosing a Location 4.1 Outdoor Location 4.2 Indoor Location 5.0 Power Supply Requirements All US/Canada 120/240 VAC Convertible Models (60 Hz) All Export 230-240 VAC Models (50 / 60 Hz) 6.0 Electrical Wiring Instructions 7.0 Start-Up Instructions Refer to sections 14.2-14.3 (page 30). Refer to section 14.1 (page 29). 7.1 Filling the Spa 7.2 Safety Check 7.3 Initiating Water Circulation 7.4 Adding Start-Up Chemicals 8.0 Control Panel Functions 9.0 Operating Instructions 9.1 Setting Water Temperature Note: The first press of either WARMER or COOLER button displays the set temperature. 9.2 Pump Button 9.3 Light Button 9.4 Solo Massage Selector / Air Control Operation 9.5 Metro Massage Selector / Air Control Operation 9.6 Caprio Massager / Air Control Valve Operation 9.7 Filtration Options 9.8 Standard Skimming/Heating Modes (F0 - F3) 9.9 Economy Skimming/Heating Modes (F4 - F6) Note: these modes consume far less energy than standard modes F0-F3 outlined above. 9.10 Lock Modes (L1 - L2) 9.11 Selecting The Skimming/Heating Mode 10.0 Care And Maintenance 10.1 Cleaning The Filter ALWAYS TURN POWER TO HOT TUB OFF BEFORE CLEANING THE FILTER CARTRIDGE! B Refer to the filter cleaning/replacement procedure below. F 18 A C 10.2 Draining And Refilling Refer to section 13.1 (page 28). 10.3 Cleaning The Spa Interior 10.4 Cleaning The Pillows 10.5 Maintaining The Cover 10.6 Maintaining The Wood Cabinet 10.7 Maintaining The Synthetic Cabinet 10.8 Winterizing The Spa 10.9 Maintaining Water Quality f 10.10 Controlling pH 10.11 Sanitizing / Using Additives 11.0 Error Conditions / Error Messages 11.1 Summer Logic 11.3 Panel displays 11.2 Overheat Condition F (35 SN2 11.6 Panel displays 11.5 Panel displays FL1 or FL2 COL 11.7 Panel displays 12.0 Troubleshooting Procedures 12.1 No Components Operate (e.g. Pump, Light) 12.2 Pump Does Not Operate But Light Does 12.3 Poor Jet Action just 12.4 Water is Too Hot 12.5 No Heat 13.0 Spa Equipment Packs 13.1 Solo Equipment Pack 13.2 Metro Equipment Pack 13.3 Caprio Equipment Pack 14.0 Spa Overhead Views 14.1 Solo Overhead View 14.3 Caprio Overhead View 14.2 Metro Overhead View 15.0 120/240 VAC Convertible Circuit Diagram Panel Control J1 * 16.0 230VAC 50Hz Dedicated Circuit Diagram Control Panel NL GRN TB1 17.0 Specifications 17.1 Solo Specifications - Export Models (50/60Hz): 2-Speed/2.0 hp Continuous, Page 17.2 Metro Specifications -Export Models (50/60 Hz): 2-Speed/2.0 hp Continuous, Page 17.3 Caprio Specifications - Export Model (50 Hz/60 Hz): 2-Speed / 2.0 hp Continuous,