Specifications
Design
Magnetically Shielded
Drive Units
HF: Waveguide loaded Neodymium Ribbon
LF: Dual
Frequency Response
95 Hz to 40 kHz
Crossover Frequency
1.5 kHz
Maximum Power
400 watts
Minimum Power
25 watts Sensitivity (2.83 V/1 meter)
90 dB
Maximum Output
115 dB
Impedance
8 ohms nominal
Connections
Gold plated
Finish
Ebonized Rosewood
Dimensions
| |
Height | 8.25" (210 mm) |
Width | 5.5" (140 mm) |
Depth | 6.0" (152 mm) |
Weight | 9 lbs (4.1 kg) |
| |
Height | 6.0" (152 mm) |
Width | 17" (432 mm) |
Depth | 3.75" (96 mm) |
Weight | 10.5 lbs (4.8 kg) |
Troubleshooting
The Cinema Ribbon loudspeakers are designed and built to provide years of
The following information will help you deal with common problems you may ex- perience during normal use. If a problem persists, please contact your Dealer for assistance.
Poor or no sound
•Check all the connections from the loudspeaker to the amplifier or receiver. Swap loudspeakers around, and see if the poor sound follows a particular loudspeaker.
•Check that your amplifier is not driven too hard or is clipping. Even a
•Many processor/preamps can send test tones through all the loudspeakers in your system. Use this to adjust the volume of each channel until they are all playing at the same level. Make sure that any bass management options are set correctly, and any channels using the Cinema Ribbons are set to "small."
•If the system bass is weak only when playing surround sources, check that your processor is correctly set to decode the surround modes, such as Dolby Digital or DTS.
•Some DVD discs have a menu that allows you to select which soundtrack to play. Check that the correct surround audio soundtrack is selected.
© 2006 Sunfire Corporation.
All rights reserved. Sunfire Corporation reserves the right to improve its products at any time. Therefore, specifications are subject to change without notice.
Manual
10 
User's Manual