Sunfire HRS-SAT4 Features, Mounting Brackets Anti-vibration pads, Binding Posts, Kickstand

Features		HRS-SAT4C
1
2
3	3 1	4 3 2 1
HRS-SAT4
1. Mounting Brackets	3.	Anti-vibration pads

The satellite loudspeaker has one keyhole bracket that allows for wall mounting and fitting onto the optional stand.

The center channel loudspeaker has two keyhole brackets, and can be mounted horizontally or vertically.

2. Binding Posts

The loudspeakers each have a pair of 5-way binding posts, that accept bare

These pads can be fixed to the bottom of the loudspeakers if they are not wall mounted, and can be fixed to the rear panel if they are wall-mounted. They can also be fitted along the bottom edge of the HRS-SAT4C to allow it to tilt further up if required (see below).

To stand the center speaker vertically on a shelf, use the pads on the rear of the touching face to allow the speaker to stand vertically (or they will tilt back).

wire, pin connectors, spade connec- tors, banana and dual-banana plugs*.

Always use high quality connections and speaker wires, and make sure there are no loose fittings or stray wire strands.

Connect the positive speaker-level output of your power amplifier or receiver to the positive (red) input of the loudspeaker. Connect the negative speaker-level output of your power am- plifier or receiver to the negative (black) input of the loudspeaker.

Make sure that the positive and nega-

4. Kickstand

This supports the rear of the HRS-SAT4C, and allows it to tilt up or down. Tighten the knurled nut when you have found the best position.

If you are wall-mounting the loudspeaker, then the kickstand and nut must be removed. Keep them in a safe place.

5. Grille

Tilt down

Flat

Tilt up

Tilt up more with pads

tive connections do not touch, or this may damage your power amplifier.

*Note that the banana and dual-banana plugs will not work if the loudspeakers are wall-mounted, or if the HRS-SAT4 is fitted on the optional stand.

The grilles are attached with magnets. To remove them, gently pry away from the corners. The magnetic logo badge on the HRS-SAT4C fits either vertically or horizontally in shallow recesses

in the grille, depending on how you are using the loudspeaker.

User's Manual