RISK OF SERIOUS INJURY OR DEATH. When using side rails, use a mattress thick enough and wide enough so that the gap between the top of the mattress and the bottom of the side rails and the gap between the side of the mattress and the side rails is small enough to prevent a patient from getting his or her head or neck between the mattress and the side rail. Assure that articulating the bed, head section or foot section does not create any hazardous gaps. Failure to do so could result in injury or possible suffocation.
RISK OF SERIOUS INJURY OR DEATH. When using side rails, only use side rails that can be positioned so that the gap between the headboard or foot board and the side rails is small enough to prevent a patient from getting his or her head or neck between the mattress and the side rail or large enough that the trunk and hips can easily pass through it. Assure that articulating the bed, head section or foot section does not create any hazardous gaps. Failure to do so could result in injury or possible suffocation.
RISK OF SERIOUS INJURY OR DEATH. When using side rails, only use side rails in which any gaps between the rail body members are small enough to prevent a patient from getting his or her head or neck inside the rail body. Failure to do so could result in injury or possible suffocation.
RISK OF SERIOUS INJURY. When using multiple side rails on one or both sides of the bed, only use side rails that can be positioned so that the gap between the side rails is large enough that the trunk and hips can easily pass through it. Assure that articulating the bed head section or foot section does not create any hazardous gaps.
ASSEMBLY INSTRUCTIONS (FIGURE 1)
1.Remove the mattress from the bed.
2.Place the bed in the flat position.
3.Measure the width of the bed frame. Attach the two crossbrace assemblies together.
4.Place the assembled crossbrace on the bed frame. Attach clamps as shown and tighten wing nuts until secure. Prevent the lock nut from contacting the bed frame.
5.Once the crossbrace is adjusted properly, tighten the center bolts and nuts.
6.Repeat steps
7.The slide tube can be rotated with the locking knob on the right or left by rotating the slide. The bed rail can be adjusted higher or lower based on your rail height preference.
8.Insert the rail into the slide tubes. Pull the plunger knob to adjust the rail height.
Center Bolts
Slide Tube 
Wing
Nuts
Plunger Knob
Figure 1
