Sunrise Medical S-626 instruction manual Thermal ROLL-BACK, Joystick Assembly, Circuit Breakers

36	X . O p e r a t i n g G u i d e
2. To Program Your Chair:
a.	Turn off power to the chair.
b.	Insert QTRONIX Programmer plug (A) into the
	charger/programmer socket on the front of the
	joystick.
c.	Turn on power to the chair; program as needed.
d.	Remove plug and cycle ON/OFF switch to drive
	chair.	A
NOTE– Review the Qtronix Programmer Owner’s Manual
	for more details on how to program your chair.
NOTE– Program settings that are not matched for the
	capabilities of the rider can result in serious
	injury. Do not alter settings without the advice
	of your health care professional.

C. THERMAL ROLL-BACK

Your chair has a thermal roll-back circuit. This protects the controller from damage due to overheating. In extreme conditions (such as repetitive hill climbing) the circuit will decrease the power to your motors. This allows the chair to operate at a reduced speed. When the controller cools, the chair will return to normal speed.

X . O p e r a t i n g G u i d e		37
E. JOYSTICK ASSEMBLY	B
The joystick connects to a controller, which controls		E
the chair’s performance. The joystick assembly consists		F
of the following parts:	G	D
1. Speed Control Knob (D):	H
Use the speed control knob to adjust the maximum
speed of your chair. Turn it counter-clockwise to reduce
speed; turn it clockwise to increase speed.		A
2. Battery Charge Indicator (B):	Remote Joystick

• Green lights indicate that batteries are fully

charged.

• Yellow lights indicate that batteries need

recharging.

• When the lights stay in the red band, the bat-

teries must be recharged.

3. On/Off Mode Switch (A)

The on/off mode switch is located on the rear face

of the joystick housing. It is a toggle switch.

Turning the chair on or off, is accomplished by

pressing the switch downward. The switch will

automatically return to the center point. Alternate

locations exist for this switch. Please see your

supplier in the event that you wish to relocate or

D.CIRCUIT BREAKERS

1. Notes:

Your Quickie S-626 has a battery box with a circuit breaker.

•In the unlikely event of a short circuit or heavy overload, all power to your chair will be shut off.

•To reset your chair, depress the circuit breaker button (B) on the front right side of the battery box. A few minutes wait is required before the circuit breaker will reset.

2.Repeated Shutdown:

If the chair continues to shut down after resetting, have it serviced by a supplier.

B

re-orient this switch.

4. Mode Switch (A)

The on/off mode switch allows you to select from 5 (five) different programmable drive profiles or actuator mode sets.

•Push up the on/off mode select toggle switch to index among the five drive and actuator modes. The selected mode indicator will flash.

•Push joystick either left or right to select one of the five drive profiles. To select the actuator modes, push the mode select switch twice.

•The drive profiles are indicated by the mode indicators (G) and the actuators are indicated by the four actuator lights (H).

•To exit drive or actuator mode select, simply push the on/off/mode toggle up one or more times until the indicator no longer flashes, or from the mode select, push the joystick forward or reverse to begin driving.

930570 Rev. C 930570 Rev. C