24 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Combustible
Finished Wall
Materials This Area Must Remain
Clear of Combustible
Materials
Top of Appliance
1" Min
(25 mm)
Spacer
Louver Face Models
Top of Door Frame
Combustible
material
may touch the
appliance top.
Hood must be installed as shown.
Louvers
Combustible
materials not
allowed below
this point on the
face of the
appliance.
12 (305) MANTEL
10 (254) MANTEL
8 (203) MANTEL
6 (152) MANTEL
4 (102) MANTEL
4
(102)
14
(356) 12
(305) 10
(254) 2 (51) MANTEL
TOP OF
APPLIANCE
6
(152)
NOTE - Hood shown as positioned
in louvered front model. The hood
position in the flush faced front model
is lower than shown.
8
(203)
MANTEL CLEARANCESInches (mm)Figure 59
Figure 61
COLD CLIMATE INSULATION
If you live in a cold climate, seal all cracks around your appliance with noncombustible material
and wherever cold air could enter the room. It is especially important to insulate outside chase
cavity between studs and under floor on which appliance rests, if floor is above ground level.
Non-combustible materials, such as surrounds
and other appliance trim, may be installed on
the appliance front face with these exceptions:
they must not cover any portion of the glass or
louvers; they may cover any portion of the top
radiant panel or the air gaps surrounding the
top radiant panel up to the installed hood.
Vertical installation clearances to combustible
mantels vary according to the depth of the
mantel. See
Figure 61
. Mantels constructed
of non-combustible materials may be installed
at any height above the appliance opening;
however, do not allow anything to hang below
the hood.
A hearth extension is not required with this
appliance. If a hearth extension is used, do not
block the lower control compartment door.
Any hearth extension used is for appearance
only and does not have to conform to standard
hearth extension installation requirements.
Note: Combustible wall finish materials and/or
surround materials must not be allowed to
encroach the area defined by the appliance
front face (black sheet metal). Never allow
combustible materials to be positioned in
front of or overlapping the appliance front
face. See Figure 58 and Figure 59.
Figure 58
Combustible
Finished Wall
Materials This Area Must Remain
Clear of Combustible
Materials
Top of Appliance
1" Min
(25 mm)
Spacer
Clean Face Models
Top of Door Frame
Hood must be installed as shown.
Radiant panel
Combustible
material
may touch the
appliance top.
Combustible
materials not
allowed below
this point on
the face of the
appliance.
17"
14" Min. Distance To
Unprotected Side Wall
8 ¹⁄₄"
45°
Combustible Materials
Allowed In Shaded
Area “Safe Zone”
12"
5"
Min. Distance
To Protected
Side Wall
Top View Of
Fireplace
Side
Wall Side
Wall
Combustible materials may project beyond the
sides of the fireplace opening as long as they
are kept within the shaded areas illustrated in
Figure 60
.