7
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Your Fireplace's Model Number ________________________________________Your Fireplace's Serial Number ________________________________________The Date On Which Your Fireplace Was Installed ___________________________Your Dealer's Name ________________________________________________
Bi-Fold Doors 20M30 FDBD36-B
Bi-Fold Doors
Your fi replace is fi tted standard with beautiful bi-fold
doors. Model FDBD36-B doors have a handsome
bright brass fi nish.
To ensure warranty and to prevent a potential
fi re hazard, do not use any other doors on these
appliances.
ACCESSORY COMPONENTS
Brass Exterior Trim Kit 19M16 FETK36-B
Exterior Trim Kit
A decorative exterior trim kit is available for use with
this fi replace. This kit is designed to attach to the
fi replace front face around the fi rebox opening. It is
available in a beautiful bright brass fi nish to provide
a dramatic enhancement to the appeal of the fi replace
in the home. (ref. Form #750,113M)
Brass Louver Kit 19M15 FLK36-B
Louver Kit
A decorative louver kit is available to enhance and
beautify the front face of your fi replace. This kit is
designed to attach directly to the fi replace front face
over the standard louvers. They are available in a
bright brass fi nish. (ref. Form #750,112M)
WARRANTY
• This fi replace is covered by a limited warranty
detailed separately from this document.
• Retain this manual. File it with your other
documents for future reference.
PRODUCT REFERENCE INFORMATION
If you encounter any problems or have any ques-
tions concerning the installation or application
of this system, please contact your distributor or
installer. For the number of your nearest Superior
dealer, please call 1-800-953-6669.
LHP
1110 West Taft Avenue
Orange, CA 92865
Figure 5
Less Than 10'
3'
Min
2' Min.
10' 3'
Min
6. Is a vent fan, exhaust hood or central heating/cooling system stealing combustion air from your
fi replace? If their volume is high enough, this can cause negative pressure and an unwanted down-
draft – and smoking.
7. Is your wood fuel too wet or unseasoned?
Or does it contain some chemical substance that causes sputtering, smoking and toxic fumes?
8. Figure 5 illustrates the correct height of your chimney top. It is unlikely that your installation
does not adhere to the installation instructions. However, if not correct, you could experience an
unusual downdraft. Usually, the best solution is to increase the chimney height. This may also be
necessary if nearby trees, adjoining roof lines or a hill is causing a downdraft condition.
9. Remember, your fi replace is not intended to heat your entire home.
REPLACEMENT PARTS
A complete parts list is found at the end of
this manual. Use only parts supplied from the
manufacturer.
Normally, all parts should be ordered through
your Superior distributor or dealer. Parts will be
shipped at prevailing prices at time of order.
When ordering repair parts, always give the
following information:
1. The model number of the appliance.
2. The serial number of the appliance.
3. The part number.
4. The description of the part.
5. The quantity required.
6. The installation date of the appliance.
Set of 6
Louvers
ACCESSORY COMPONENTS
ON/OFF Wall
Switch Kit
This ON/OFF wall switch kit
can be used in place of the
standard variable speed wall
switch (see Page 8). This
switch provides single speed
ON/OFF operation of the
blower. Install the ON/OFF
wall switch in a convenient
location near the fi replace.
White Wall Switch Kit
Cat. No. Model No. Description
85L87 FWSK ON/OFF Wall Switch Kit