Connecting the Heater / Blower Power
Connect the wires you passed through the seal plug to the Heater / Blower power terminals with the positive and negative wires as marked in this illustration. Once the wires are in the screw terminal holes,
+ -tighten the screws down to give the wires a good electrical connection.
Turn the camera on and adjust the focus to suit your requirement then close the top of the 1060 housing. Using a “Philips Head” screwdriver, re- tighten the two screws at the side of the 1060 housing to ensure the best possible weather seal.
Opening the 1060 Housing
Turn the 1060 Housing
Turn the 1060 housing back to right side up and open the top sideways to allow access to the camera mounting plate fitted to the mounting rails at the bottom of the inside of the housing. Gently prise the base plate up with your hand, or use a screwdriver if this is too difficult.
6 | 3 |
